The procedure for placement of a CEREC restoration is very simple. The first step is to remove all decay from the tooth. The doctor will then shape the tooth in preparation to take a digital picture. The tooth is then sprayed with a very fine powder. This allows the digital camera to take an acceptable image. Once this image is captured, the tooth will appear on a computer screen in 3D. This will allow the doctor to design the restoration right in front of you. Once the design is completed, the CEREC will mill the restoration. This step takes approximately 15 minutes. You can actually watch this process if you would like. When the restoration is finished milling, the doctor will place the restoration. The entire process should take just over an hour.